Intellinet-network IDC-862 Hardware Installation Guide Manuel d'utilisateur télécharger pdf (Page 6)

3) Attached the drill template to the wall. Drill three holes into the wall (two for

screws and one for the connection cable if you want to route cables through

conduit hole). Then push the supplied plastic anchors into the screw holes and

secure the plate with supplied screws.

4) Align the three holes on the base of camera with the two plastic anchors on the

wall or ceiling, insert the supplied screws to the corresponding hole and screw

them.

5) Adjust the angle of camera to aim the shooting area.

1 2 3 4 5 6 7 8 9

Pas de commentaire

Intellinet-network IDC-862 Hardware Installation Guide Manuel d'utilisateur Page 6