Intellinet-network 524681 User Manual Manuel d'utilisateur télécharger pdf (Page 94)

Remote IP Specify the remote (destination) IP address

Address: (e): that will be affected by this rule. Input the

starting IP address in the left field and input the

end IP address in the right field to define a

range of IP addresses, or just input the IP

address in the left field to define a single IP

address.

Remote Port Input the range of remote (destination) port

Range (f): number that will be affected by this rule. If you

want to apply this rule on ports 80 to 90, input

“80-90”; if you want to apply this rule on a single

port, just input the port number, such as “80.” If

the remote (destination) IP address and/or port

number is universal, just leave it blank.

Traffic Type (g): Select the traffic type of this rule. Options are

“None,” “SMTP,” “HTTP,” “POP3” and “FTP.”

You can select a specific traffic type for this rule:

If you want to make this rule an IP address-

based rule (apply the limitation on all traffics

from/to the specified IP address/port number),

select “None.”

Protocol (h): Select the protocol type of this rule. Options are

“TCP” and “UDP.” If you don’t know what

protocol your application uses, try “TCP” first

and switch to “UDP” if this rule doesn’t seem to

work.

After you finish the settings, click “Save” (i). You’ll be brought back

to the previous menu, and the rule you just set will appear in the

current QoS table; if you did anything wrong, you’ll get an error

message when you click “Save.” Correct your entry as instructed by

the error message.

If you want to erase all the values you just entered, click “Reset.”

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 141 142

Pas de commentaire

Intellinet-network 524681 User Manual Manuel d'utilisateur Page 94