Intellinet-network NSC11-WN User Manual Manuel d'utilisateur télécharger pdf (Page 14)

1.7 Find the camera on your network

Connect the RJ45 network cable from the camera’s LAN port to your network; e.g.,

the router or a LAN switch, then power on the camera. The boot sequence will

take about one minute. By default, the network camera searches for a DHCP

server on the network and obtains an IP address automatically. A very common

DHCP server is a router, a device that is found on most networks. The presence

of a DHCP server on your network simplifies the installation and users with limited

knowledge of TCP/IP networks can install the network camera in minutes. If no

DHCP server is found, the network camera will revert to its default IP address:

192.168.1.221.

On Windows systems, you want to use the IPCam Admin

Utility that finds the camera on the network and lets you

make changes to the configuration.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 76 77

Pas de commentaire

Intellinet-network NSC11-WN User Manual Manuel d'utilisateur Page 14